QB-V850MINIL, QB-V850MINI Emulator Safety Precautions
R20UT0221EJ0400 Rev.4.00
Page 9 of 86
2013.08.30
CAUTION
Cautions to Be Taken for Turning On the Power:
Observe the following specified order for the power-on and power-off procedures of the user
system and the emulator. Doing otherwise may cause the user system or the emulator to fail.
Power ON: (1) Emulator power ON, (2) User system power ON, (3) Start emulator debugger
Power OFF: (1) Exit emulator debugger, (2) User system power OFF, (3) Emulator power OFF
Cautions to Be Taken for Handling This Product:
Use caution when handling the product. Be careful not to apply a mechanical shock.
Do not touch the connector pins of the emulator and the target MCU connector pins directly.
Static electricity may damage the internal circuits.
When attaching and removing the cable, hold the plug of the cable and do not touch the cable.
Do not pull the emulator by the communications interface cable or the flexible cable. And,
excessive flexing or force may break conductors.
Note on Transporting the Product:
When sending your product for repair, use the packing box and cushioning material supplied with
the product when it was delivered to you and specify caution in handling (handling as precision
equipment). If packing of your product is not complete, it may be damaged during transportation.
When you pack your product in a bag, make sure to use the conductive plastic bag supplied with
the product (usually a blue bag). If you use a different bag, it may lead to further trouble with your
product due to static electricity.
Caution to Be Taken for System Malfunctions:
If the emulator malfunctions because of interference like external noise, do the following to
remedy the trouble.
(1) Exit the emulator debugger, and shut OFF the emulator and the user system.
(2) After a lapse of 10 seconds, turn ON the power of the emulator and the user system again,
then launch the emulator debugger.
Caution to Be Taken for Disposal:
Penalties may be applicable for incorrect disposal of this waste, in accordance with your national
legislation.
European Union regulatory notices:
The WEEE (Waste Electrical and Electronic Equipment) regulations put responsibilities on
producers for the collection and recycling or disposal of electrical and electronic waste. Return of
WEEE under these regulations is applicable in the European Union only. This equipment
(including all accessories) is not intended for household use. After use the equipment cannot be
disposed of as household waste, and the WEEE must be treated, recycled and disposed of in an
environmentally sound manner.
Renesas Electronics Europe GmbH can take back end of life equipment, register for this service
at “http://www.renesas.eu/weee”.
