QB-RL78D1A2 In-Circuit Emulator CHAPTER 2 SETUP PROCEDURE
R20UT3110EJ0101 Rev.1.01
Page 29 of 41
Nov 28, 2014
2.5 Notes on Power Supply and GND Pin Connection
For power supplies and GND pins of the target device, be sure to connect all pins to each power supply or GND.
2.6 Connecting USB Interface Cable and AC Adapter
Plug the USB interface cable supplied with the QB-RL78D1A2 into the USB connector of the host machine, and plug the
other side into the USB connector on the rear of the QB-RL78D1A2.
Plug the AC adapter into the power supply connector on the rear of the QB-RL78D1A2 and plug the other side into a
receptacle.
For QB-RL78D1A2 connector positions, see Figure 2-8.
Figure 2-8. Connector Positions
2.7 Switching Power On and Off
Be sure to switch the power on and off according to the following procedures.
- Switching power on
- Switching power off
<1> QB-RL78D1A2 power on
<1> Debugger termination
<2> Target system power on
Note
<2> Target system power off
Note
<3> Debugger startup
<3> QB-RL78D1A2 power off
Note
In the procedures, <2> is unnecessary if the target system is not connected.
Caution
If the wrong sequence was used for the operation, the target system or QB-RL78D1A2 may fail.
Power supply connector
(Connect AC adapter)
USB connector
(Connect USB interface cable)
Summary of Contents for QB-RL78D1A2
Page 40: ......
Page 41: ...R20UT3110EJ0101 QB RL78D1A2 In Circuit Emulator User s Manual...
