Renesas J80D1, User Manual

Page: 8 / 17

Voice over PLC Sample Application Operating Manual 3. Operating procedure
R11UM0083EJ0200 Rev.2.00 Page 4 of 9
June 25, 2018
RENESAS CONFIDENTIAL
RENESAS Group CONFIDENTIAL
User specifies the destination Node IDs in decimal. If the Node ID is one, unicast transmission is
started, if the Node ID is multiple, multicast transmission is started. When specifying multiple Node IDs,
the user specifies the node IDs separated by spaces.
3.3.2 Duplex
User specifies the destination Node ID in decimal. Only one Node ID is specified.
3.4 Data Send menu
User specifies the destination Node ID in decimal. Only one Node ID is specified.
Continuously, the user sets the sending data in hexadecimal. The maximum data size that can be
transmitted is 64 bytes. Sending data must be entered consecutively without separating.
3.5 Setting menu
1. Menu for initializing EEPROM.
2. Menu for individually editing the set values.
3. Menu for displaying the current set value.
4. Menu for erasing EEPROM.
The sample application reads the initial setting value from EEPROM and starts application process.
When invalid value is written in EEPROM, sample application starts with the default setting value. The
default setting values are follows.
Extend Addr : 0xABCDABCDABCD0000
Node ID : 000
Bitrate : 32000
Sampling Rate : 8000
Modulation : BPSK
3.5.1 Initialization for EEPROM
The value of EEPROM is changed to the default value. The default values are follows.
Extend Addr : 0xABCDABCDABCD0000
Node ID : 000
Bitrate : 32000
Sampling Rate : 8000
Modulation : BPSK
Dest Node ID>
---------------------------------------------
Dest Node ID>
Send Data( 01FF...)>
1: Init config
2: Edit config
3: Disp config
4: Erase config
---------------------------------------------
>