3 Before starting the debugger
3.3.4 Proprietary parallel communication
If you are using this debugger in a combination of the parallel I/F, you need to specify the start
address of I/O addresses (7 bytes) to the device driver for PCA4202G02, (The I/O address for
PCA4202G02 is set to 100h initially.) You can set this setting with setPca4202.exe included with this
debugger. The above programs are installed in the directory where this debugger is installed. At the
first time of using this debugger,or when you want to change the I/O address for PCA4202G02
because of conflict with other devices, please follow the procedure of the setting described below.
1. Execute
setPca4202.exe
included with this debugger. The dialog box shown below will appear.
2. Find the I/O address that is set on the PCA4202G02 parallel board and input it in hexadecimal
into the I/O Address input field. Click "OK" button.
3. Restart
Windows.
ATTENTION
•
Make sure setPca4202.exe is executed by one who is authorized as an Administrator. No one but
the user who has the authority of an Administrator can install the device driver.
•
For detail about parallel board PCA4202G02, refer to "PCA4202G02 Instruction Manual".
19
Summary of Contents for Emulator Debugger M16C PC4701
