Renesas 89HPES24T3G2ZBAL, User Manual

Page: 29 / 165

IDT PES24T3G2 Device Overview
PES24T3G2 User Manual 1 - 9 February 22, 2012
Notes
JTAG_TRST_N I JTAG Reset. This active low signal asynchronously resets the boundary
scan logic and JTAG TAP Controller. An external pull-up on the board is
recommended to meet the JTAG specification in cases where the tester
can access this signal. However, for systems running in functional mode,
one of the following should occur:
1) actively drive this signal low with control logic
2) statically drive this signal low with an external pull-down on the board
Signal Type Name/Description
REFRES0,
REFRES1
I/O Port 0 External Reference Resistors. Provides a reference for the Port 0
SerDes bias currents and PLL calibration circuitry. A 3 kOhm +/- 1% resis-
tor should be connected from these pins to ground.
REFRES2,
REFRES3
I/O Port 2 External Reference Resistors. Provides a reference for the Port 2
SerDes bias currents and PLL calibration circuitry. A 3 kOhm +/- 1% resis-
tor should be connected from these pins to ground.
REFRES4,
REFRES5
I/O Port 4 External Reference Resistors. Provides a reference for the Port 4
SerDes bias currents and PLL calibration circuitry. A 3 kOhm +/- 1% resis-
tor should be connected from these pins to ground.
V
DD
CORE I Core V
DD.
Power supply for core logic.
V
DD
I/O I I/O V
DD.
LVTTL I/O buffer power supply.
V
DD
PEA I PCI Express Analog Power. Serdes analog power supply (1.0V).
V
DD
PEHA I PCI Express Analog High Power. Serdes analog power supply (2.5V).
V
DD
PETA I PCI Express Transmitter Analog Voltage. Serdes transmitter analog
power supply (1.0V).
V
SS
I Ground.
Table 1.8 Power, Ground, and SerDes Resistor Pins
Signal Type Name/Description
Table 1.7 Test Pins (Part 2 of 2)