12
Wall Mounting Instructions for a Wall with Wooden Stud Spacing other than 16”
Before mounting your Air Mag M.W. II to a wall with stud spacing other than 16” .
You must provide a solid attachment point by first securing a wooden mounting plate to the wall. This wooden plate should be
18” x 3” and 1.5” thick at least and suitable for receiving the hex head lag screws ( provided in hardware kit ) which will hold the Air
Mag M.W. II . You will need to provide lag screws and washers to attach this mounting plate to the wall.
1. Determine the location of the studs in your wall.
2. Mark the center of the studs. Measure the distance between them.
3. Mark 4 marks on each piece of wood 1” from the top, 1” up from the bottom, and separate by the stud spacing in your wall.
4. Drill through holes at each of these locations.
5. Install the piece of wood such that the center line of the top piece is 80” above the floor, and the lower piece is resting
on the floor .
NOTE:
If you have a wooden baseboard, you may attach the Air Mag M.W. II directly to the baseboard.
6. You may now follow steps 2 ~ 10 from the previous Air Mag M.W. II mounting instructions using the mounting hardware
provided.
Wooden
Plate
80”
5/16” Hex Head Lag Screw
x 8
5/16” Washer
x 8
Wrench (13/17mm )
Hardware Kit - Provided
The minimun force supported shall be
202 kg.
!
The minimun force supported shall be 202 kg.
!