Renegade Labs Gray|328
Adjusting Edit System Controls
The Edit I/F System Menu is used to determine how the Gray|328 is
controlled by ESAM II.
Figure 110. EDIT I/F System Menu
1.
Press the MENU button to bring up the System Menu.
2.
Press EDIT to display the EDIT I/F Menu.
Turning Controls ON and OFF
•
Use the EDIT I/F soft button to enable or disable all ESAM II Control.
•
Use the CTRL SEL control to scroll through and select a control (see
list of controls below).
•
Use the CHANGE soft button to toggle the control on or off.
•
Press the ENTER soft button to accept the setting changes.
OR,
Press the CANCEL soft button to cancel any setting changes.
Available Edit System controls:
•
PREVIEW
: When PREVIEW is on, the mixer's PGM OUT button is
controlled by the edit system. When PREVIEW is off, PGM OUT
control from the edit system is disabled.
•
PARITY
: Parity selects the RS-422 communications parity type.
Possible selections are ODD, EVEN, and NONE.
•
BUSMAP
: Bus mapping allows edit systems that can only control four
buses the ability to control additional buses. For example, if the edit
system sends a command to transition bus 1, with bus mapping the
same command could also transition bus 5. The BUS SEL control will
toggle between edit system buses 1 &2 and buses 3 & 4 while the
keypad section is used to select which buses they are mapped to.
•
GPI:
GPI enables or disables the external GPI trigger. The GPI allows
for external triggering of the TRAN button. Refer to “CUT/TRAN
buttons“ on page 19 for information regarding the TRAN button and
“Appendix A: Installation Information“ on page 106 for additional
information regarding the GPI interface.
•
REC
: With REC on the mixer will accept previewing commands from
the edit system and will use the Record Returns for Auto Record
previewing. Refer to “Auto Record“ on page 89 for information
regarding Auto Record. When REC is off whatever inputs assigned as
Record Returns will always be selected for record return monitoring.
Page 92
ESAM II Control
