Rendamax E8.1121, Operating Instructions Manual, Page: 13 / 44

Operation
Overview of display values and settings
INSTALLATION
(HG => heat generator)
Select parameter using
Ç
=> value is displayed
OUTSIDE TEMP Outside temperature
HS SET TEMP HG temperature setting
T-HS HG flow temperature
RETURN-TEMP
SOLID FUEL-T
COLLECTOR-T
COLLECTOR-T
CIRCL TEMP
CIRCL-PULSE
T-DHW LOWER
HEAT CIRCUIT 3 HS return temperature
Temperature of the heat generator for solid fuel
Header temperature
Temperature of the solar collector
Return flow temp. of the circulation
Circulation via pulse
Temp. of the hot water tank lower measuring
point (see hot water functions)
Additional direct heating circuit
RETURN Exit level using
Ä
Display Range
~ Hinged cover OPEN
Î
search for
level to the right with Ç , open with Ä
!
Display only. No adjustments
possible.
!
Display only appears if the sensor
is connected and the value is
present in the system.
If the set value is not present it is
masked out, or hyphens appear in
the display (- - - -).
OUTSIDE TEMP
The measured outside temperature is
smoothed for control purposes. The
smoothed value is displayed here.
HG SET TEMP
Corresponds to the maximum required
temperature of the consumer circuits
from the heating system (incl. hot water
preparation). The mixer circuits request
the tempe heating curve
distance (expert value)
T-HS
Measured actual temperature of the
heat generator
Temperature of the multifunction
relay
RETURN-TEMP = Return temperature
of system
SOLID FUEL-T = Temperature of the
heat generator for solid fuel, =>
T-BUFFER LOWER = Temperature of
the storage tank at the inlet area
T-COLLECTOR-H = Collector
temperature
T-COLLECTOR = Temperature of the
solar collector,
=> T-BUFFER LOWER = Temperature
of the storage tank at the inlet area
(display only if sensor is connected)
T-CIRCL = Return temperature of the
circulation pipe
CIRCL PULSE = for circulation pump
via pulse the pulse input status is
displayed (ON/OFF)
DHW-T-LOWER = Temperature of hot
water storage tank at inlet area
HEAT CIRCUIT 3 = for additional direct
heating circuit the pulse input status is
displayed (ON/OFF)
13