1.11 Transport and packaging
The devices are supplied in a sturdy shipping con-
tainer. Please check the equipment immediately
upon delivery and note any damage or missing
parts on the delivery and inform the shipper and
your contractual partner. For later complaints can
not be guaranteed.
WARNING!
Plastic films and bags etc. are dangerous
toys for children!
Why:
- Leave packaging material are not around.
- Packaging material may not be accessible to
children!
1.12 Environmental protection
and recycling
Disposal of packaging
All products are packed for transport in environ-
mentally friendly materials. Make a valuable contri-
bution to reducing waste and sustaining raw mate-
rials. Only dispose of packaging at approved
collection points.
Disposal of equipment and components
Only recyclable materials are used in the manufac-
ture of the devices and components. Help protect
the environment by ensuring that the devices or
components (for example batteries) are not dis-
posed in household waste, but only in accordance
with local regulations and in an environmentally
safe manner, e.g. using certified firms and recy-
cling specialists or at collection points.
2
System requirements
Note the following!
Programming can only be carried out via a KNX
system integrator.
Programming cannot be carried out by REMKO
Service.
Prerequisite for using the Smart Com function:
1.
Products with REMKO Smart Control con-
troller as of software level 4.24. Check the
software in the software version number
information & software control panel level.
Both versions must have level 4.24.
2.
The integrated Gira 216800 interface can be
connected directly to the KNX bus.
The heat pump can also be commissioned
without integrating the KNX-BUS. For this pur-
pose, leave the plug connections of the network
cables in the delivery state: Touch display and
I/O module are connected to each other, the
network cable on the KNX module (plugged into
the I/O module connection) remains uncon-
nected.
In the LWM series heat pumps and the SQW
modular energy centres, the interface is not
installed at the factory. In this instance, it is
enclosed as a separate item. For these series,
the installation must then take place in a suit-
able position provided by the customer (e.g.
main control box of the house or separate sub-
distribution).
REMKO Smart Com
6
Summary of Contents for Smart Com
Page 31: ......
