"Timer"
You can switch the unit on and off automatically
with the timer. The switch on delay or switch off
delay can be programmed for this.
Automatic switch on
1.
Switch the unit on with the "Power" key
1
.
2.
Select the operating mode and implement all
settings for the desired operating mode.
3.
Switch the unit off with the "Power" key
1
.
4.
Press the "Timer"
4
key.
5.
Adjust the time via the "Timer/Temp. Adjust"
5
/
6
key. You can only enter full hours.
6.
LED
11
flashes.
Automatic switch off
1.
The unit operates in the previously selected
operating mode.
2.
Press the "Timer"
4
key.
3.
Adjust the remaining runtime via the "Timer/
Temp. Adjust"
5
/
6
key. Only full hours can
be entered.
4.
LED
11
illuminates.
5.
Unit switches off automatically after the
preset time.
NOTICE!
You will achieve a pleasant room temperature
if you set the desired target temperature max.
4 to 7 °C below the outside temperature.
Help save on energy consumption in stand-by
mode! If the device, system or component is
not in use, we recommend disconnecting the
power supply. Components with a safety func-
tion is excluded from our recommendation!
5
Assembly and
installation
Assembly and unit installation instructions
The unit is positioned at the desired location with
the discharge side pointing into the room. When
positioning, observe the following instructions:
n
After unpacking the unit let it sit on its transport
rollers for at least 5 minutes before you switch
it on.
n
Set the unit down in a stable position on a level
and firm floor. If the floor is uneven then this
can lead to vibrations and disturbing noises.
Fig. 5: Unit installation
NOTICE!
There must be a minimum clearance of 20 cm
between the rear of the unit and the wall.
n
All extensions to the power supply must be of a
sufficient cable size and must only be used
fully rolled out.
Fig. 6: Power supply
11
