5.2 Setting up the unit
For the best economic and safe use of the units,
the following notes must be followed in full:
n
The units must be set up in an upright and
level position in order to ensure unhindered
operation of the unit
n
It must be ensured that the air can be sucked
in at the rear of the unit and blown out of the
top of the unit without obstruction (min. 50 cm
minimum clearance)
n
Observe a minimum clearance of 20 cm from
walls on all sides at all times
n
Units must never be set up in the immediate
vicinity of heaters or other sources of heat
n
The area of application must be closed to the
neighbouring atmosphere
n
The output of the unit is dependent on the con-
ditions inside the room, room temperature, rel-
ative humidity and particle emissions
n
No emission sources should be located near
the indoor air quality sensor. (left side of the
unit)
RE
M
KO
500
200
200
Fig. 12: Minimum clearances (all measurements in
mm)
- Keep windows and doors closed!
- Keep at least 0.2 m away from walls.
- Maintain adequate clearance from heaters or
other sources of heat.
The air purifier should be placed as centrally as
possible in the middle of the room to achieve
optimum air circulation
R
EM
K
O
Fig. 13: Set up in the middle of the room
If it is not possible to set up the unit in the middle
of the room, it can also be set up on the side of a
wall.
Fig. 14: Set up on the side of the room
REMKO
15
