Before using read the important
safety instruction section in front of
the manual.
Preparing the System
Cleaning solution:
1.
Press the latch
buttons on the
sides of the
cleaning base
and lift the upper
portion off the
unit. You will
need to keep the
buttons pressed
in as you move
the upper portion
away from
the base. The
cleaning solution
tank is in the
unit’s bottom
portion.
2.
Remove the filter
from the tank
and set aside.
3.
Pour the bottle of cleaning solution
into the base of the unit through
the opening where the filter was
removed.
4.
Place the filter back into its original
position.
8
How To Use
2
3
NOTE: It is important to make sure
the filter is in place. The filter collects
hair clippings and debris, and should
be replaced along with the solution.
Failure to do so will permanently clog
the system rendering it inoperable.
5.
Replace the top portion of the
cleaning base by lining up the
three posts with the three holes
in the tank. Push the top portion
down until the two latches click
into place.
6.
You can dispose of the bottle and
cap with your normal trash, or
recycle where local ordinances
apply.
Charging
Prior to using your shaver for the first
time, put it on charge for 24 hours.
Note: It may take up to 3 cycles for
the battery to reach full capacity.
Using Cleaning Base
Plug the power cord into the clean-
ing base and then into an electrical
outlet.
Make sure arm is full up position
before inserting shaver. Push down
to release arm. It will "pop-up".
Place the shaver into the unit, head
side down, and slide its “tail” toward
the “neck” of the base until it stops.
Push the arm down until it contacts
the shaver (clicks into place).
Charging
Your shaver automatically begins to
recharge as soon as it is in place in
the cleaning base. While it is charg-
ing, the blue indicator light will flash;
when it is fully charged the blue light
will stop blinking and glow steadily.
Your Shaver can also be recharged
by plugging it into the cord directly.
■
Use only the charging adapter
supplied with the shaver.
■
Make sure your shaver is turned
off.
■
Connect the cord to the shaver,
then plug the charging adapter into
the electrical outlet. A charging
indicator light will come on.
■
Your shaver cannot be
overcharged, so you can leave it
plugged in and charging between
shaves.
■
To preserve the life of the
batteries, let them fully run out
every six months, then recharge
them for a full 24 hours.
■
Cord/cordless rechargeable
shavers can run directly off the
cord if necessary. They will not
recharge while you are shaving,
so after shaving with the cord,
turn the unit off and set it aside
to charge. Cord/cordless shavers
should not be used strictly as cord-
operated shavers, as continued
cord-only use will result in
reduction of battery life.
■
Quick Charge provides up to 60
min. of shaving after a one-hour
charge, or a single shave after a
five-minute charge.
NOTE: If your shaver battery is
completely discharged or the shaver
has not been used for a long time,
the shaver may not start when oper-
ated using the cord. If this happens,
charge the shaver for approximately
five minutes before shaving.
NOTE: It may take up to 3 cycles for
the battery to reach full capacity.
1
9
32651_MS-900 IB.indd 8-9
2/19/07 2:09:18 PM
