Remington Durablade MB010, Manual

Page: 4 / 8

4
• Connect the product to the USB cable and then connect the USB end of the cable to
a powered USB port.
• When fully charged, the charging indicator will come on.
• Run time from fully charged is up to 40 minutes.
• Charge time from empty is 12 hours.
Note: To preserve the life of your batteries, let them run out every 6 months then fully
charge.
INSTRUCTIONS FOR USE
Switch the product on by pressing the On/Off switch.
Always comb your beard or moustache with a fine comb before you start trimming.
Attaching and removing the combs
1. Select the desired trimming length comb. Place the comb over the top of the blade
and gently push this down onto the blade until it clicks into place.
2. To remove the comb, grasp the comb and pull firmly upwards and away from the
groomer.
To trim the beard
1. Select your desired trimming length comb. If you are trimming for the first time start
with the maximum trimming length setting.
2. Turn the unit on.
3. Place the flat top of the fixed comb against the skin.
4. Slowly slide through the hair. Repeat from different directions as necessary.
5. If hair builds up in the trimmer comb during the trimming process, switch the unit
off, pull off the comb and brush the hair off.
To get a shaven look
To trim any length of beard or stubble hair for a clean, shaven look then follow the above
steps without a comb attached to the blade head.
Place the flat top of the blade against the skin and slowly slide through the hair against
the direction of growth.
Trimming and edging
1. Hold the groomer with the back side of the blade facing you with no combs
attached.
2. Start with the blades resting lightly against your skin, use motions towards edge of
beard line to trim to desired locations in facial area.
3. Shape as desired.