23
UM Neya EN rev.0 28.02.2022
9.
SYSTEM Menu
In the menu there are some settings of the centrifuge that operator can modify.
Figure 22
With closed lid and the centrifuge in standby mode (see Picture 4), press shortly SETUP/ESC
button, the display
passes
in SETUP menu and the word “PROGRAM” starts to blink (see
Picture 22). Turn the knob
to move the
selection on “SYSTEM” and press the knob to confirm. The display passes in the next menu in which there are
present two items:
•
SYSTEM
•
SERVICE
Rotate the knob
to move the selection on “SYSTEM” and press the knob to confirm.
The display passes in the next menu in which there are present the follow items:
•
END cycle beep
•
Speed limit
•
Time/Date adjustment
•
Temperature unit
•
Factory reset
•
END cycle beep
This function permits to enable or disable the audible signal of the end of centrifugation. By the knob
select this
parameter, modify in ON or OFF and confirm by pressing of the knob.
•
Speed limit
This function permits to set a speed limit that centrifuge cannot overcome even if in the program is set a higher
speed. By the knob
select this parameter, increase or decrease the value and confirm by pressing of the knob.
•
Time/Date adjustment
By the knob
select, modify and confirm time and date.
•
Temperature unit
By the knob
select this parameter, modify in °C or °F and confirm by pressing knob.
•
Factory reset
This function permits to reset all the above parameters to the factory conditions.
By the knob
select this parameter, modify in ON and confirm by pressing of the knob.