REMET CNC TECHNOLOGY SP. Z O.O.
Page 16 z 22
Manufacturer of machinery and equipment, CNC machining service
8.
REPLACING AND ALIGINIG THE BLADE AXIS
Before adjusting the position of the knives or replacing them, disconnect the
device from the power source and place it on a stable, level and non-slippery sur-
face.
Knife adjustment scheme:
1. Adjust the blades by loosening the M12 lock screws (2) and the M8 lock nuts
(3) and partially unscrew the M8 screw (4).
2. Then loosen the M10 screws (1) locking the counter-blade (A) and slide the
counter-blade (A) inside the cutting chamber from 3 mm to obtain the finest
chips, or up to 14 mm to obtain the thickest chips, after determining the position
of the counter blade, tighten the screw -by (1).
3. We start to set the cutting knives, use the M8 adjusting screws (4) to set the
clearance from 1 mm to 2.5 mm in relation to the counter-blade (A) and then
tighten the blade using M12 allen screws. We adjust the adjusting screws (4).
Note: Each blade (B) relative to the counter blade must be set separately with
the same clearance.
1 - M10 screw, 2 - M12 screw (blade), 3 - M8 counter nut, 4 - M8 screw, A - Counter-blade, B - Blade
Summary of Contents for RT-630
Page 22: ......
