REMEHA Quinta Pro 115, Installation, User And Service Manual

Page: 51 / 88

9 Settings
9.1 Parameter descriptions
Tab.32 Factory setting
Parame­
ter
Description Adjustment range 30 45 55 65 90 115
Flow temperature: T
SET
20 to 90ºC 80 80 80 80 80 80
DHW temperature: T
SET
40 to 65ºC 55 55 55 55 55 55
Boiler control/DHW
0 = CH off/DHW off
1 = CH on/DHW on
2 = CH on/DHW off
3 = CH off/DHW on
1 1 1 1 1 1
ECO setting
0 = Comfort
1 = ECO setting
2 = Controller dependent
2 2 2 2 2 2
Anticipation resistance
0 = No anticipation resist­
ance for the ON/OFF ther­
mostat
1 = Anticipation resistance
for the ON/OFF thermostat
0 0 0 0 0 0
Display screen
0 = Simple
1 = Extended
2 = Automatic switching to
simple after 3 minutes
3 = Automatic switching to
simple after 3 minutes; key
lock is active
2 2 2 2 2 2
Post-circulation of the pump
1 to 98 minutes
99 minutes = continuous
3 3 3 3 3 3
Brightness of display lighting
0 = Dimmed
1 = Bright
1 1 1 1 1 1
Maximum fan speed (central heat­
ing)
G20 (H gas) x100 rpm 41 56 51 58 62 70
Maximum fan speed (DHW) G20 (H gas) x100 rpm 41 56 51 58 62 70
Minimum fan speed (CH + DHW) G20 (H gas) x100 rpm 15 15 16 16 17 18
Minimum fan speed (offset) G20 (H gas) 50 50 0 0 0 0
Start speed G20 (H gas) x100 rpm 25 25 25 25 25 25
Minimum water pressure 0–3 bar (x 0.1 bar) 8 8 8 8 8 8
Maximum flow temperature of sys­
tem
0 to 90°C 90 90 90 90 90 90
Reserve - - - - - -
Heat curve set point
(Maximum outside temperature)
0 to 30ºC
(1)
20 20 20 20 20 20
Heat curve set point
(Flow temperature)
0 to 90ºC
(1)
20 20 20 20 20 20
Heat curve set point
(Minimum outside temperature)
-30 to 0ºC
(1)
-15 -15 -15 -15 -15 -15
Setting the pump speed
(Minimum pump speed for central
heating operation)
2–10 (x 10%) 4 4 4 4 4 4
9 Settings
123157 - v.12 - 07022018 51