7. When the pump has stopped, vent again and top up the water
pressure.
Important
Filling and venting the installation twice a year should be sufficient
to obtain an adequate hydraulic pressure. If it is often necessary
to top up the installation with water, contact your installer.
10.3.6 Cleaning the casing
1. Clean the outside of the boiler using a damp cloth and a gentle
detergent.
10.4 Specific maintenance operations
10.4.1 Carrying out an auto-detect
Carry out an auto-detect after removing or replacing a control PCB.
Proceed as follows:
1. Press the key.
2. Select Advanced Service Menu / This will send a command to
autodetect all devices connected to the Local Bus
The selection options appear on the screen:
Cancel
Confirm
3. Select Confirm
4. The auto-detect is carried out and after a while the main display
appears.
10.4.2 Other specific maintenance operations
In addition to the maintenance operations described in this manual, please
also ensure that the maintenance operations listed in the boiler manual
are carried out.
See
Boiler installation and service manual.
On
10 Maintenance
7717201 - v03 - 25062019
MID _HMI T-control - Gas 120 ACE
79
