ACTIVATION AND SELF-TEST PROCDURES
Activating the Unit/LED Light Sequence:
Before inserting the strap into the unit, press the Activation button on the face of the unit
The PWR LED light will turn on
A red PWR LED light indicates a low battery, the unit should be charged before placing it
on an offender
A green PWR LED light indicates a good battery charge
Make a clean cut on one side of the strap
Insert one side of the strap into the unit using the pin tray and locking clip
Measure the strap around the offenders ankle and cut the strap length as needed
Place the pin tray on the end of the strap and insert the locking clip into the unit, then place the
unit on the offender
Press and hold the Activation button for two seconds
The unit will vibrate
The PWR LED light will begin flashing
During the activation process, if the PWR LED light is blinking red this does not indicate a
low battery. This means that the unit is waiting to receive the IP address from the server
The GPS and ZONE LED lights will begin flashing green. These two LED lights will flash together
during the activation process. Initially, they will blink once every second
A Download can be sent to the unit at this time (
the download should not be sent before this
sequence
) - but within 5 minutes.
