46
7.3.
Rotor position, rotor damping and rotor suspension
The rotor must be set in such a way that the vertical distance between the rotor tine tips and
pick-up is around 6cm.
Collision of rotor with pick-up
Rotor tines can break if they come into contact with the pick-up.
The distance between the rotor tine tips and the pick-up should not be less than 6cm.
7.4.
Headland position
Put the two hydraulic control units on
“pressure” (
+). This will raise the two units. At the
headland, the conveyor belt is to be brought to a standstill, because otherwise the crop is
scattered at the headland.
7.5.
Swath roller
The height of the swath roller can be adjusted using the holing rods.
Two upper and two lower positions are available.
Basic setting: lowest position of the swath roller
Height adjustment of the rotor (distance from
rotor to pick-up)
1.
Loosen lock nut.
2.
Raise the rotor position: turn screw
clockwise.
3.
Lower the rotor position
4.
Retighten lock nut.
