OPERATOR’S MANUAL ULTRA GUIDANCE PSR ISO
PAGE 95
CHAPTER
PSR SONIC
6.6.
PSR SONIC drive modes
All drive mode pictures show the sensors placed as the driver will
see them from the drivers seat in forward driving direction.
6.6.1. Track Cross
Display:
Main screen
Set drive mode according to the adjoined picture (see chapter
4.5.).
Advice!
In the drive mode Track Cross a measurement
shows a slight deviation to the left or right of the guide
line.
Set sensors:
Set sensors according to adjacent picture. Pay attention that the
measuring ray hits the inside of the edge to be read.
For setting the distance, use a tape measure.
Advice!
Depending on the job, it might be advisable to
install the sensors behind each other instead of side by
side. In that situation, get a double reading of the same
track which may improve accuracy. This might be
workable when following a marker track when seeding.
Picture 161:
Sensor Direction Track Cross
Picture 162:
Main Screen Track Cross
Picture 160:
Main Screen Track Cross
Picture 163:
Sensor placement behind one another
