PAGE 6
2.3 Safety Instructions for Installation and Service
Installation and servicing require that the sequences are known.
If technically possible, measurements, installation and servicing work concerning GREEN FIT must always be
carried out with the vehicle fully at standstill and with the engine switched off. The operator of the vehicle
must ensure that the vehicle cannot be started unintentionally or against prior arrangement by unauthorised
persons and that the vehicle cannot roll away and thereby people can be harmed. As necessary, remove the
ignition key.
Also comply with the following installation and servicing regulations:
• Keep the workplace clean and dry.
• Do not work in potentially explosive atmospheres.
• Appropriately use and properly dispose of cleaning agents, substances and materials.
• When operating the vehicle, please be mindful of components which may have become hot.
• Use a ladder or platform to be able to install, remove or maintain components in elevated positions. Make
sure that you are standing in a stable and sure position and your hands cannot slip off.
• Do not take measurements or carry out installation or maintenance work in elevated positions in wet or
icy weather conditions.
• Please consider the safety instructions regarding electrics (see Chapter 2.4) and hydraulics (see Chapter 2.5).
• Replace any worn or damaged parts.
• Report or repair any damage immediately.
• Always make sure that all parts are in a sound condition and have been installed properly.
Electrical cables
should not be pulled over sharp edges. This can damage the cables.
• Look out for damaged or incorrectly installed electrical lines. These may cause severe electric shocks.
• Obtain parts to be replaced (hoses, screws, brackets, etc.) only via Reichhardt, to ensure proper function
and safety of the vehicle and GREEN FIT.
