REGO Thermal Printer Technical Manual
www.regotek.com
48
[Times]
B2
178
Number of auto cutter operations.
[Times].
C6
198
Duration
of
printer
operation.
[Hours].
[Notes]
The maintenance counter values are measurements; therefore, their values will be affected by
the timing of errors and how and when the power is turned off.
When this command is transmitted, the data following must not be transmitted until the status is
received.
[Reference]
GS g 0
FS ! n Set print mode(s) for Chinese characters
[Name]
Set print mode(s) for Chinese characters
[Format]
ASCII
FS
!
n
Hex
1C
21
n
Decimal
28
33
n
[Range]
0 ≤ n ≤ 255
[Description]
Set the print mode for Chinese characters, using n as follows:
Bit
0/1
Hex
Decimal
Function
0
0
00
0
Chinese Font A(24 × 24)
1
01
1
Chinese Font B (16 × 16)
1
Undefined.
2
0
00
0
Double-width mode is OFF.
1
04
4
Double-width mode is ON.
3
0
00
0
Double-height mode is OFF.
1
08
8
Double-height mode is ON.
4~6 -
-
-
Undefined.
7
0
00
0
Underline mode is OFF.
1
80
128
Underline mode is ON.
[Notes]
When both double-width and double-height modes are set (including right- and left-side
character spacing), quadruple-size characters are printed.
The printer can underline all characters (including right- and left-side character spacing), but
cannot underline the space set by HT and 90° clockwise-rotated characters.
The thickness of the underline is that specified by FS -, regardless of the character size.
When some of the characters in a line are double or more height, all the characters on the line
are aligned at the baseline.
It is possible to emphasize the Kanji character using FS W or GS !, the setting of the last received
command is effective.
It is possible to turn under line mode on or off using FS -, and the setting of the last received
command is effective.
[Default]
n = 0
[Reference]
FS - , FS W, GS !
