Assembly instructions
Attention!
The PITT
®
by Reginox-system may only be connected by an approved installer. To
ensure the safety and warranty repairs may only be performed by approved professionals. You
should only use original parts.
Defect
Cause
Solution
Manual
A burner ignites
and turns off
again.
The control knob is not pressed
long enough to activate the flame
protection.
Hold the button pressed for a
few seconds after igniting.
See user manual.
The control knob is not adjusted
at the correct height.
Reset the control knob.
Assembly instructions
step 19 t/m 22.
The control-but-
ton touches the
sealing scale.
Hob is not mounted the right way
under the countertop.
Reset the control knob.
Assembly instructions
step 14 t/m 22.
Sealing scale is not in the center
vs. control knob.
Detach sealing scale and adhere
again.
Assembly instructions
step 25 t/m 26.
Spark ignition
remains igniting.
Hob is not mounted the right way
under the countertop
Set the control knob well off.
Assembly instructions
step 14 t/m 22.
Sealing scale is not in the center
vs. control knob.
Detach sealing scale and adhere
again.
Assembly instructions
step 25 t/m 26.
A burner does not
kindle.
The control knob is not adjusted
at the correct height.
Reset the control knob
Assembly instructions
step 19 t/m 22.
The plug is not in the
outlet.
Insert the mains plug into the
wall outlet.
Installation instructions
step 13.
Fuse is defect or the central fuse
is turned off.
Mount a new
fuse or switch on the fuse again.
Spark ignition is polluted or
humid.
Clean or dry the spark ignition
See user manual.
Burner parts are not mounted
correctly.
Put the burner parts together by
the spigot.
See user manual.
Burner parts are polluted or
humid.
Clean/dry the
Burner parts. Make sure the
outflow holes are open.
See user manual.
Main gas tap is closed.
Open the main gas tap.
Control knob is not pressed long
or deep enough.
Keep the control knob pressed
long enough and sufficiently
between full-and small gas.
See user manual.
A burner is not lit
evenly.
Burner parts are not properly
placed.
Burner parts are not properly
placed. Put the burner parts
together by the spigot.
See user manual.
Burner parts are polluted or
humid.
Clean/dry the burner parts. Make
sure the outflow holes are open.
See user manual.
Gas smells in
surroundings of
cooker.
Gas connection leaks.
Check the connection. Turn main
gas valve off when you’re not
able to fix it right away.
There is a burner turned on, but
not ignited.
Close the control knob and wait
a few minutes with rekindling.
See user manual.
Reginox Far East
PITT
®
by Reginox
2 Loyang Lane # 03-03
Singapore 508913
Reginox The Netherlands
PITT
®
by Reginox
Noordermorssingel 2
7461 JN Rijssen
T + 65 (0)67 88 53 63
F + 65 (0)67 88 38 35
[email protected]
T + 31 (0)548 53 56 35
F + 31 (0)548 53 56 00
[email protected]
www.pittbyreginox.com
www.pittbyreginox.com
