✓
ALAM
- Alarm settings
To access the parameter menu and set a parameter value:
1. Press the up and down buttons simultaneously, for about 5 seconds, until the
SERVICE
indication is
shown in the display.
2. Press the up button twice to enter the parameter menu. The
CTRL
group heading is shown by default.
3. Use the up or down button to scroll to the applicable group heading, and then press the occupancy
(on/off) button to access the parameters in the group.
4. Use the up or down button to scroll to the applicable parameter, and then press the occupancy (on/off)
button to enter edit mode for the parameter.
5. Use the up or down button to select a parameter value, and then press the occupancy (on/off) button
to set the selected value. During parameter value selection, the currently set value can be retrieved by
pressing the up and down buttons simultaneously.
Back navigation in the parameter menu structure can be done in the following ways:
✓
Press the up and down buttons simultaneously.
✓
Use the up or down button to scroll to the
EXIT
value and then press the occupancy (on/off) button.
The display returns to normal view mode after 2 minutes of inactivity in the parameter menu.
3.3.6
Parameter menu access
Access to the parameter menu in room units with display can be disabled to prevent unauthorized users to
perform basic controller configuration.
The configuration setting for disabling or enabling access to the parameter menu is listed in section
.
3.3.7
Display background lighting
The display background is lit, and dimmed after 2 minutes of inactivity, when the controller is in:
✓
Bypass state
✓
The state specified by the
Preset controller state
setting
✓
The state specified by the
Controller state when presence detected
setting
The display background is not lit when the controller is in the state specified by the
Shutdown controller state
setting.
Configuration options for setting the display background brightness are listed in section
3.3.8
ED-RU-DOS functions
ED-RU-DOS is a multipurpose room unit with display. In addition to having up/down buttons for setpoint
adjustment and an occupancy (on/off) button for putting the room HVAC system in comfort or energy
saving mode, this model is equipped with a multi-function button (
) that can be used for:
✓
Selecting a fan speed
- auto fan speed or the available (as configured in the controller) manual fan
speeds
✓
Performing a setpoint adjustment
- increase or decrease
Regio
Eedo
manual, Rev. D
53