Regin REGIO EEDO, Manual, Page: 73 / 108

Room unit display parameter lists
Appendix B Room unit display parameter lists
B.1 CTRL
Parameter Signal name Default
value Units Description
1 RCPSettings.RegioControllerMode 9 Control Mode
0=Heating
1=H Heating
2=H Cooling
3=Cooling
4=Heating/Cooling (change-over)
5=H Heating/Cooling (change-over)
6=H VAV
7=C VAV
8=VAV
9=H C VAV
2 RCPSettings.RegioHeatSetPointOccupied 22 °C Room Base setpoint heating
3 RCPSettings.RegioCoolSetPointOccupied 24 °C Room Base setpoint cooling
4 RCPSettings.RegioRoomTempPBand 10 Temperature PID P Band
5 RCPSettings.RegioRoomTempITime 300
sec
Temperature PID I Time
6 RCPSettings.RegioHeatSetPointUnoccupied 15 °C Setpoint heating in Unoccupied
7
RCPSettings.RegioCoolSetPointUnoccupied 30 °C Setpoint Cooling in Unoccupied
8 RCPSettings.RegioSetPointDeadBandStandby 3 °C Deadband in Standby mode
9 RCPSettings.RegioFrostProtectionSetPoint 8 °C Setpoint frostprotection
10 RCPSettings.
RegioSupplyAirTempLimCascadeFactor 3 Cascade Factor for the Cascade PID
11 RCPSettings.RegioSupplyAirTempLimHeatMinLimit 24 °C Min Setpoint for the Cascade PID in Heat
Mode
12 RCPSettings.RegioSupplyAirTempLimHeatMaxLimit 35 °C Max Setpoint for the Cascade PID in Heat
Mode
13 RCPSettings.RegioSupplyAirTempLimCoolMinLimit 12 °C Min Setpoint for the Cascade PID in Cool
Mode
14 RCPSettings.RegioSupplyAirTempLimCoolMaxLimit 24 °C Max Setpoint for the Cascade PID in Cool
Mode
15 RCPSettings.
RegioSupplyAirTempLimFrostProtSetPoint 8 °C Supply Air Temp Frost Protection Temperature
16 RCPSettings.RegioCO2PBand 100 CO2 PID P Band
17 RCPSettings.RegioCO2ITime 100
sec
CO2 PID I Time
18 RCPSettings.RegioCO2SetPoint 600
ppm
Setpoint for CO2 PI Controller in PPM
B.2 SYS
Parameter Signal name Default
value Units Description
1 RCPSettings.RegioControllerStateReturn 3 Select return unit state:
0=Off
1=Unoccupied
2=Stand-by
3=Occupied
2 RCPSettings.RegioControllerStateShutDown 1 Select shutdown state :
0=Off
1=Unoccupied
2=Stand-by
3=Occupied
Regio Eedo manual, Rev. D 73