Regin REGIO EEDO, Manual, Page: 52 / 108

Room unit
Table 3-4 Display indication descriptions. (continued)
Indication Description
Turning: The fan is active.
Blinking: Fan speed selection is in progress.
EC or 3-speed fan control in auto or manual mode. The fan speed is shown in the following ways:
When 3 speeds is configured in the controller as number of used fan speeds, one of these indications is shown:
When 2 speeds is configured in the controller as number of used fan speeds, one of these indications is shown:
When 1 speed is configured in the controller as number of used fan speeds, one of these indications is shown:
Controller is in heating mode and the demand is greater than zero.
Controller is in cooling mode and the demand is greater than zero.
Forced ventilation is active.
Room unit is in service mode, in which the parameter menu can be accessed.
Room window is open.
Lighting is active.
Sun blind is out.
Relative humidity level in room is shown temporarily.
Note: Only the ED-RU-DOS model supports showing the relative humidity level in the display.
Outdoor temperature is shown temporarily.
Note: Only the ED-RU-DOS model supports showing the outdoor temperature in the display.
3.3.5 Basic controller configuration via the display
Basic controller configuration can be performed via the parameter menu in room units with display. The
room unit display parameters are listed in
Appendix B .
The parameter menu is divided into the following groups:
✓
CTRL - Controller mode, setpoint, P-band, and I-time settings
✓ SYS - Controller state, change-over, presence detection, and lighting control settings
✓
ACTR - Actuator settings
✓
FAN - Fan control settings
✓
M/AT - Manual / Auto settings
✓
HMI - Room unit settings
✓
IO - Input / Output settings
AUTO
No fan speed Fan speed 1 Fan speed 2 Fan speed 3
No fan speed Fan speed 1 Fan speed 2
No fan speed Fan speed 1
MAN
HEAT
COOL
SERVICE
RH
52 Regio Eedo manual, Rev. D