IMPORTANT NOTICE
Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.
Check to be sure that you have a ll parts and hardware.
Remove all wrapping materials, including staples & packing straps before you start to assemble.
Do not tighten all screws/bolts until completely assembled.
Keep all hardware parts out of reach of children.
Any problems or questions please call Regency Office Furniture at 1-866-816-9822
A
B
C
D
E
F
G
A. Table Top
B. Large Base
C. Cylinder
D. Spider
E. Rod
F. Foot (4)
G. Screws (8)
Square Table Top INSTRUCTIONS
(MKTBX22, MKTBX30, MKTBX36, TTSQ3030, TTSQ3636, TTSQ4242, TTSQ4848)
Step 1:
Screw 4 feet
(F)
into
base
(B) leg ends
.
Step 2:
Remove the nuts from
the rod (E), set the nuts aside.
STEP 4:
Place spider down so the spider is flush on floor and rod
is sticking straight up. Insert cylinder (C) over rod so the flat side is
touching the spider flush. Then place Large Base (B) into place and
screw bolt to tighten.
Organize your parts. You will need a drill,pencil and crescent wrench. Two people are required for assembly.
Step 3: Insert the rod (E) through
the hole in (D) and attach a nut to
exposed rod end. Have 1/4 inch of
rod extruding
at nut.
STEP 6: Turn Table Upside down .
Draw 2 diagonal lines across the
table bottom from upper right
corner to lower left then lower
right to upper left.
STEP 7:
Place dot 1, located on
the template, directly over the
crossing lines.
1
STEP 8:
Once aligned punch a
pen through remaining tem-
plate dots 2,3,4,5 and mark
table bottom.
1
2
11
3
4
5
STEP 10:
Line up marks made
on the table from step 8 holes
on spider arms.
STEP 11:
Drill in all 8 screws (G)
and flip table over.
STEP 9:
Place
table top
(A)
flat
on the floor and
set the
completed base
(H)
over the
center.
H
1
2
3
4
5
2
3
4
5
1
1
