Reflex iC60H, Reference Manual

Page: 22 / 44

Use
22
A9MA03EN 02/2012
Operating Modes
Introduction
All versions of the Reflex iC60 integrated control circuit breaker, with and without Ti24 interface, have 2
control inputs (Y1 and Y2). In addition, the version with Ti24 interface has an additional control input (Y3)
dedicated to control from a PLC.
The Reflex iC60 version without Ti24 interface has 2 operating modes: mode 1 and mode 2. Mode 1 is
the default mode.
The Reflex iC60 version with Ti24 interface has 3 operating modes: mode 1, mode 2 and mode 3. Mode
3 is the default mode.
Reflex iC60 integrated control circuit breaker functions
The following table describes the available functions according to the type of Reflex iC60 circuit breaker.
Mode Function Input/Output A9C5••••
(without
Ti24) A9C6••••
(with Ti24)
1 Local closing control on rising edge and opening control on
falling edge Y1
√ √
Local one-shot closing and opening control Y2
√ √
Centralized closing control on rising edge and opening
control on falling edge (conforming to standard IEC 61131-2) Y3 –
√
2 Local opening control on rising edge, latched at high state
(state = 1) to inhibit local one-shot closing and opening
control Y1
√ √
Local one-shot closing and opening control Y2
√ √
Centralized closing control on rising edge and opening
control on falling edge (conforming to standard IEC 61131-2) Y3 –
√
3 Centralized control enabled (Y1 = 1) or centralized control
inhibited (Y1 = 0) Y1
√ √
Local one-shot closing and opening control Y2
√ √
Centralized closing control on rising edge and opening
control on falling edge (conforming to standard IEC 61131-2) Y3 –
√
1, 2, 3 Indication of the position (open/closed) of the circuit breaker
contacts O/C –
√
Indication of the position of the circuit breaker handle. auto/OFF –
√