Technical data
Fillcontrol Auto Compact — 20.10.2020 - Rev. D
English — 5
4.5
Scope of delivery
The scope of delivery is described in the shipping document and the content is
shown on the packaging.
Proceed as follows:
1.
Immediately after receipt of the goods, please check the shipment for
completeness and damage.
2.
Please notify us immediately of any transport damage.
Basic make-up equipment:
•
The pre-wired device.
•
Operating manual.
4.6
Optional equipment and accessories
The following optional equipment and expansion functions are available for this
device:
•
Fillset or Fillset Compact as add-on modules for drinking water systems.
•
Softening with Reflex Fillsoft.
•
Expansions for Reflex Basic controllers:
–
I/O modules
–
Bus modules:
•
Profibus DP
•
Ethernet
Note!
Separate operating instructions are supplied with accessories.
5
Technical data
Permissible ambient temperature
0 – 45 °C
Degree of protection
IP 54
Noise level
55 dB
Electric output
350 W
Power supply
230 V / 50 Hz
Fusing
4 A
Number of RS-485 interfaces
2
Weight
19.1 kg
Height
620 mm
Width
580 mm
Depth
290 mm
Inlet connection
G ½"
Outlet (return) connection
G ½"
Overflow connection
DN 32
Delivery rate
≤
195 l/h
Max. supply pressure
6 bar
Max. delivery pressure
≤
10 bar
Permissible gauge operating pressure
10 bar
Permissible operating temperature
30 °C
I/O module
Optional
Performance chart
M
ake
-u
p
capac
ity
in
li
tre
/h
ou
r
Make-up pressure in bar
6
Installation
DANGER
Risk of serious injury or death due to electric shock.
If live parts are touched, there is risk of life-threatening injuries.
•
Ensure that the system is voltage-free before installing the device.
•
Ensure that the system is secured and cannot be reactivated by other
persons.
•
Ensure that installation work for the electric connection of the device is
carried out by an electrician, and in compliance with electrical
engineering regulations.
CAUTION
Risk of injury due to pressurised liquid
If installation, removal or maintenance work is not carried out correctly, there
is a risk of burns and other injuries at the connection points, if pressurised
hot water or hot steam suddenly escapes.
•
Ensure proper installation, removal or maintenance work.
•
Ensure that the system is de-pressurised before performing installation,
removal or maintenance work at the connection points.
CAUTION
Risk of burns on hot surfaces
Hot surfaces in heating systems can cause burns to the skin.
•
Wear protective gloves.
•
Please place appropriate warning signs in the vicinity of the device.
CAUTION
Risk of injury due to falls or bumps
Bruising from falls or bumps on system components during installation.
•
Wear personal protective equipment (helmet, protective clothing,
gloves, safety boots).
Note!
Confirm that installation and start-up have been carried out correctly
using the installation and commissioning certificate. This action is a
prerequisite for the making of warranty claims.
–
Have the Reflex Customer Service carry out commissioning and
the annual maintenance.
