Reflex Marine FROG-6 HC6-01 620, User Manual

Page: 15 / 97

User Manual FROG-6
UM-0007-REV.06 Page 15
3.2 Operating Parameters - Sea State
The FROG-6 has an inbuilt damping system which prevents passengers from experiencing
shock loads up to relative landing and take-off velocities of 4.0 m/s (13.1 ft/s). The maximum
recommended sea state, or significant wave height, for the operation of the FROG-6 is determined
by the maximum relative velocity between the FROG-6 (or hook) and the landing deck.
The calculation for relative velocity used here is based on the European offshore crane standard, EN
13852-1:2004. Whereby the maximum anticipated relative velocity between a load and a vessel
deck, is given by the following;
Relative velocity = Hook velocity* + √ (Vessel deck v elocity
2
+ Boom tip velocity
2
)
* Equal to 1.67 m/s (100 m/min, 330 ft/min) for lifts below 5 tonnes. Higher crane hook speeds may be available, and it
follows that the higher the available crane speed the higher the possibility of a heavy landing or take off. However, with
a qualified Crane Operator, it is considered unlikely that the FROG-6 will be landed at full hook speed on a deck rising at
full speed.
If there are concerns about heavy landings, operators may wish to consider the following methods to reduce risk of
heavy landings and take-off; dry runs without passengers, landing in centre of deck where less vessel movement,
transfer of fewer passengers to increase damping, hook speed indicator.
Table 1: Recommended Sea States for FROG-6
KEY

Low risk of high landing or take-off velocity and exceeding FROG-6 personnel damping.

Increasing risk of high landing or take-off velocity. Consideration of hook speed and all
other factors is recommended to ensure controlled landing and take-off. A dry run to
gauge risk (without personnel) is also recommended.

High risk of high landing or take-off velocity. Not suitable for routine operations unless
a specific hazard analysis can demonstrate otherwise.
In all cases, adequate planning and risk assessment must be performed.
Link to Index
Sig. Wave
Height
(m / ft)
Max. Wave
Height
(m / ft)
Fixed
Platform to
Vessel
Semi-Sub to
Vessel
FPSO to
Vessel
Vessel to
Vessel
≤ 1.0 m / 3 ft ≤ 1.9 m / 6 ft
   
≤ 1.5 m / 5 ft ≤ 2.8 m / 9 ft
  

≤ 2.0 m / 7 ft ≤ 3.7 m / 12 ft
   
≤ 2.5 m / 8 ft ≤ 4.6 m / 15 ft
 


≤ 3.0 m / 10 ft ≤ 5.6 m / 18 ft
 


≤ 3.5 m / 11 ft ≤ 6.5 m / 21 ft
   
≤ 4.0 m / 13 ft ≤ 7.5 m / 24 ft
 
 
≤ 4.5 m / 15 ft ≤ 8.4 m / 28 ft

  
≤ 5.0 m / 16 ft ≤ 9.3 m / 30 ft

  
≤ 5.5 m / 18 ft ≤ 10.2 m / 33 ft
   