PAGE 2
ENGLISH
ASSEMBLY INSTRUCTIONS
3086500_Rev D • Questions? (800) 234-6992 • ReeseBrands.com
1
2
Locknut
Hinge Bar
Capscrew
Bottom Ramp
Section
Top
Ramp
Section
Washer
between
Hinge Bar
and Ramp
Washer
Locknut
Washer
Center Fold Models only
1. First, assemble the hinge bars to the bottom ramp section using
the hardware (capscrew, washer and locknut) provided, as
shown in
FIG 1
. (Note: Only finger-tighten the hardware at this
time.) The washers are used as spacers between the rail and
hinge bar. (Quantity 2 per side)
2. Next, assemble the top section to the bottom/hinge assembly
using the hardware provided, as shown in
FIG 2
. Again, the
washers are used as spacers between the rail and hinge bar and
under the nut and bolt heads. (Quantity 3 per side)
3. Tighten all hardware to 25 – 30 in. lb of torque. Use caution not
to overtighten. This may cause the side rails to distort during
assembly. (Note:
FIG 2
is showing a pivot point. The two ramp
sections should fold up on themselves without excessive force.)
