Installation:
A flexible hose connection must be used between the hose reel inlet and the source of supply to prevent
possible misalignment and binding.
Mounting:
The hose reel is equipped with a universal mounting bracket so that it can be mounted on the floor, wall or
ceiling; whichever place is convenient. The hose guide arm can be moved to the position desired by removing
the screws fastening the guide bracket to the reel base. Shift the guide arm bracket so the hose comes off the
reel at the desired position and replace the screws.
Lubrication:
Hose reel spring and bearings are factory lubricated and require no further lubrication.
Replacing
Hose:
1. Wind spool flange clockwise-facing swivel-until spring is tight.
2. Back off three turns and latch.
3. Insert hose through roller guide and hole in spool flange.
4. Connect hose fitting to swivel joint and secure hose with clamps.
Adjustments:
To adjust spring tension, add or remove wraps of hose from the spool, one wrap at a time until desired tension
is obtained.
Repairs:
II.
Safety
I.
Remove all spring tension before beginning
disassembly process.
Do not use reels at higher pressures or
temperatures than listed on the back of this
bulletin.
FORM NO: 489-884
REV: 3/2009
Extensive repairs should be performed only by an authorized serviceman or factory to avoid damage which may
void your warranty. Remove all spring tension before beginning disassembly process.
Instructions
Four 5/16" Mounting holes.
Reelcraft Industries, Inc. • (800) 444-3134 / (260) 248-8188 • Fax: (260) 248-2605
E-mail: [email protected] • Internet: www.reelcraft.com
A
14 1/2”
B
13 3/4”
C
9 3/4”
D
2 1/2”
E
6”
Hose Reel
Operating Instructions and Parts List
Low Pressure Models
5400 OLP 5600 OLP
5440 OLP 5630 OLP
5450 OLP 5635 OLP