Push ENTER to store in memory. Screen will read
Use Up and Down buttons to select number of cells.
Push ENTER to store in memory. Screen will read
Use Up and Down buttons to select mAH rating.
Push ENTER to store in memory. Screen will read
Use Up and Down buttons to select Charger Current.
Push ENTER to store in memory. Screen will read
Use Up and Down buttons to select Discharge Current.
Push ENTER to store in memory. Screen will read
Use Up and Down buttons to select Trickle Current.
Push ENTER to store in memory. Screen will read
Use Up and Down buttons to select to select the mV/cell over peak cutoff.
Charger will automatically adjust to number of cells.
Push ENTER to store in memory. Screen will read
Use Up and Down buttons to select Number of Cycles (max. three).
Push ENTER to store in memory. Screen will read
Use Up and Down buttons to select Delay Time After Charge.
Push ENTER to store in memory. Screen will read
Use Up or Down buttons to select Delay Time After Discharge. Reedy recom-
mends at least thirty minutes. Push ENTER to store in memory.
This concludes the programming procedure. All settings will be stored in default
memory and will automatically be recalled when charger is turned on (charger
automatically comes on when the power source is hooked up). Any setting may be
changed by entering the program mode with the SETUP button and scrolling through
the screens until you reach the value you want to change and making your adjust-
ments using the Up and Down buttons.
You may now proceed into operational mode.
4
CELL NUMBER
X CELL
BATTERY CAPACITY
XXXX mAh
CHARGER CURRENT
X.XA
DISCHAR. CURRENT
XX.XA
TRICKLE CURRENT
X.XXA
CYCLE NUMBER
XTIME
DELAY TIME AFTER
CHARGE XXMIN
DELAY TIME AFTER
DISCHARGE XXMIN
3
4
5
6
8
9
10
11
12
PEAK AD. NiMH
XmV/C. XXmV/P.
