REED True Peel Operating Instructions Download Page 1

INSTRUCTIONS

True Peel

®

 PE Prep Tool is designed to peel both the end of the pipe 

and Tapping Tees for electrofusion. Rotate the Feed Screw Knob 

clockwise until the mandrel is fully extended. Insert the Mandrel into the 

pipe. While holding down the Blade Lever, push the mandrel all the way 

in until it reaches the small tapered section of the mandrel. Firmly press 

the mandrel into the pipe as far as possible to prevent the mandrel from 

rotating inside the pipe. Rotate the Peeler Body clockwise one to two 

turns and check to see if the end of the peel has not wedged between 

the pipe and the inside of the peeler body. If so, simply pull the end of 

the peel out and continue rotating the peeler. Rotate the peeler until the 

end of the pipe can be viewed in the center of the observation window. 

The peel is complete. Hold down on the Blade Lever to raise the blade 

while pulling the peeler off the pipe.

MANDREL REPLACEMENT

Each Reed peeler comes with a specific mandrel size for wall thick-

ness. For some body sizes, alternate mandrels are available to ac-

commodate other SDR/DR wall thicknesses. To replace the mandrel, 

remove the guide and guide screw. Remove the mandrel screw. Hold 

down the blade lever and remove and replace the mandrel.

For a full list of mandrel sizes, refer to www.reedmfgco.com.

Reed Manufacturing Company

1425 West 8th Street

Erie, PA 16502 USA

Phone: 800-666-3691 or 814-452-3691

Fax: 800-456-1697 or 814-455-1697

www.reedmfgco.com

0120-54633

True Peel

®

 PE Prep Tools

Operating Instructions

FEED SCREW KNOB

BLADE LEVER

BLADE

MANDREL

OBSERVATION WINDOW

TAPERED 

SECTION 

OF MANDREL

GUIDE

PIPE

PEELER BODY

Reviews: