X2 COMBAT Install Guide 2.0
13
1.3 Cantilever Mode - Moving the tilt-arms forwards
X2 COMBAT is able to cantilever the camera head forwards by approx. 15°, in order to see the base area of a
tower or pole clearly. In effect, this gives X2 COMBAT the ability to view a full 180° in the tilt axis, ensuring
nothing is missed. Moving the camera head into Cantilever mode is easy, simply:
1.
Remove the two fixings screws and alloy covers at the base of each tilt-arm, using the supplied Allen-key
2.
Slightly loosen the two Allen-screws on each tilt-arm
3.
Move both tilt-
arms forward to “STOP”
4.
Tighten both Allen screws on each tilt-arm
5.
Re-fit the alloy covers in place, with the hump protruding outwards
6.
Once in camera setup, navigate to
Configuration Tab>PTZ Parameter>Install Mode
and set “Upright, Arms
Out” mode and apply the setting.
Slacken both
Allen screws on
each tilt-arm,
then move head
gently forwards.
Tighten both
screws on each
side and replace
both covers.
Remove two
Allen screws
and cover
