USER MANUAL
16
8.
FIXING TORQUE CHARACTERISTICS:
The correct setting torque of fasteners is very important for your safety. Always tighten fasteners to the
correct torque. If there is any conflict between the instructions in this manual and information provided
by a component manufacturer, consult your dealer or the manufacturer's customer service
department for clarification. Bolts that are too tight can stretch and warp. Loose bolts can move and
tire. Any of these errors can cause sudden bolt failure.
Overtightening will damage the element.
Proper tightening requires a calibrated torque wrench (not included) if you don't have one, you can
ask our Red Shark Bikes team for a quote. Carefully follow the instructions to select and use the torque
wrench correctly for accurate results.
Although all accessories on this kit are important, be sure to apply the correct torque to the following
tightening torques:
POWER (Join with the handlebar):
• Handlebar clamp bolt:
Tightening torque
: 5 Newtons
• Carbon fiber handlebar fixing screw:
Tightening torque
: 10 Newtons
SADDLE: Seat fixing screw
Tightening torque
: 6 Newtons
SYSTEM TO FIX THE CONNECTING ROD:
Tightening torque
: 10 Newtons
PROPELLER:
M5 nut Tightening torque
: 10 Newtons
TRANSMISSION:
• M6 nut
Tightening torque
: 10 Newtons.
• M8 nut
Tightening torque
: 10 Newtons
RUDDER BLADE:
Tightening torque
: 3 Newtons
9.
DISASSEMBLY
IMPORTANT:
Prior to disassembly, it is important to rinse the entire assembly with plenty of fresh water,
cleaning it of dirt, sand, salt and impurities....
REVERSE THE PREVIOUS PROCESS:
At this point, you must reverse all the steps that make up the
assembly described and shown in the delivered documents.
9.1
MAIN ELEMENTS DISASSEMBLY:
• Deflate the board until it is soft but without losing its shape.
• Separate the chassis (frame) paying special attention to having the propeller and rudder
vertical so as not to damage the inflatable board.
9.2
DISASSEMBLY OF SECONDARY ELEMENTS:
• Saddle
• Propulsion
•
Propeller
• Rudder
• Handlebar
