RDL-3000
FAMILY
USER MANUAL
70-00158-03-00
Proprietary Redline Communications © 2015
Page
97
of 254
April 17, 2015
Stickiness Timer (Seconds)
: Period the subscriber continues to monitor the RF
channel for an opportunity to re-establish a link with the same sector controller. If the
wireless link is not restored within the specified period of 0 - 600 seconds, the subscriber
starts a new frequency scan.
This timer is active only when Auto Scan is enabled. This timer can be set locally on the
subscriber Wireless settings screen. This value is downloaded and overrides the local
setting on the subscriber. Updates to the sector controller setting are automatically
forwarded to connected RAS platforms. The subscriber reverts to the local setting when
a rescan in started (e.g., Stickiness Timer expired). The System Status screen displays
the active Stickiness Timer value.
Fig. 57: Web - Stickiness Timer Example
Operating Mode
: Choose the mode of operation for this wireless link.
The available operating modes are controlled by the installed options key (
). For
example, the radio may be restricted to MIMO A operation.
MIMO A
: Operate in MIMO-A mode (based on link conditions).
MIMO A/B
: Operate in MIMO-A/B mode (based on link conditions).
RF Mode
: Select the mode of operation for this link (refer to the following table).
The available RF modes are controlled by the installed options key (
). For example,
the radio may be restricted to MIMO-A operation.
Table 14: Web - RF Mode - RF Port Settings for Wireless Link
Settings
Operation
RF Mode Setting
Operating Mode
RF Port 1
RF Port 2
Op. Mode
RF Port 1
X
MIMO-A
RF Port 2
MIMO-A
X
MIMO-A
RF Port 1&2
MIMO-A
Auto
Auto
Auto
Automatic*
RF Port 1
X
MIMO-A
RF Port 2
MIMO-A /B
X
MIMO-A
RF Port 1&2
MIMO-A / B
Auto
Auto
Auto
Automatic*
* Equivalent to RF Port 1 & 2.
Important
: Links to AN-80i subscribers must be configured to use MIMO A mode
(RF Port 1
or
RF Port 2).
Controls
Apply
: Click to accept and activate displayed settings.