Red
MAX
™
Subscriber Modem
User Manual
70-00057-01-01-DRAFT
Proprietary Redline Communications © 2006
December
13,
2006
Page 48 of 60
5.3.15 softwareUpdate - Software Update Commands
Use the softwareUpdate commands to display the software versions stored in the
subscriber non-volatile memory, download software updates from an FTP server,
and switch the active versions.
Table 24: CLI - softwareUpdate - Software Update Commands
loadImage
Download software binary file and save in non-volatile memory
(inactive partition). Following download, you must enter the
reboot command to run the new software. On the next reboot
following a successful download, the subscriber will
automatically switch active partitions and run the downloaded
file.
show
Display software version information for downloaded binary files.
Indicates the active version.
switch
Switch to the currently inactive software version. Confirmation is
required. The subscriber will be rebooted. This is done
automatically following a successful file download.
sync
Synchronize the binary files saved in the active and inactive
partitions. This command copies the 'active' binary file into the
inactive partition. Following execution of this command, both
partitions (#0 and #1) will contain identical software versions.
For example:
SUO#> loadImage
Server IP Address: 192.168.101.102
File Name: SUO-U1-001-01-00-078.bin
Opening FTP connection.....
DoneDownloading image
............................................................................................……………………
............................................................................................……………………
........................................................................................
DoneProgramming update........
DoneErasing setup partition.
Done.Writing setup partition.
Done.Erasing boot block.
DoneProgramming boot block.
DoneFlash programming complete.
SUO#>reboot
