Redexim Turf-Stripper 1200, User Manual And Parts Book, Page: 14 / 26

14
7. ADJUSTING THE WORKING DEPTH
Figure 11
The working depth is set by adjusting the front roller.
The rear roller must be set to the long groove (A) for cutting and scarifying.
Adjusting:
1. Adjust the rear spindles (2) to the correct position. For this purpose, use the
indicator (see Figure 11) and block it by tightening the lock nut.
2. Adjust the front spindles (1) at both sides of the machine until the required
working depth is achieved and block it by tightening the lock nut.
3. Check the working depth by operating the machine on a few metres.
If necessary, readjust the working depth.

If the transport belt is folded out, the machine weight shifts to this side. Due to
the extra mass of the material that need to be transported, more material can
be removed at this side. You can compensate this by turning spindles (1) and
(2) in order to set the machine to less depth at this side .