RED ROCKET-X INSTALLATION INSTRUCTIONS
COPYRIGHT © 2015 RED.COM, INC
955-0033, REV-E
|
21
INSTALL RED ROCKET-X AND HD-SDI SLOT FILLER
Since each Windows-based computer is different and highly customizable, the instructions in this section
are general and cover the essential steps for installing a RED ROCKET-X and HD-SDI slot filler (optional) in a
Windows-based computer.
Depending on how your system is set up, you may need to rearrange components in your system or perform
actions not described in these instructions in order to successfully install the RED ROCKET-X and HD-SDI slot
filler. For more information about installing components in your system, refer to the computer manufacturer
instructions.
WARNING:
The computer system you are installing the RED ROCKET-X in works with voltages that can be
hazardous to your health.
1. Ensure that the computer is turned off.
2. Wait 5 to 10 minutes to ensure that the system components cool down.
3. Unplug the power cable and all external cables from the computer.
WARNING:
Never work on the system or access its interior while any power cables are plugged in.
4. Discharge any static electricity from your body.
NOTE:
To avoid generating static electricity while installing the RED ROCKET-X, DO NOT walk around the
room until you have completed the installation and closed the computer.
5. Lay the Windows-based computer on its side.
6. Open the computer casing so that you can access the PCIe slots. For more information, refer to the
computer manufacturer instructions.
Remove Panel
