RED ROCKET INSTALLATION INSTRUCTIONS
COPYRIGHT © 2015 RED.COM, INC
955-0035, REV-D
|
9
HD-SDI SLOT FILLER
The HD-SDI slot filler provides optional high-definition serial digital interface (HD-SDI) connectors for the
RED ROCKET. Installing the HD-SDI slot filler is optional. Review your system and project requirements before
you decide whether or not to install the HD-SDI slot filler.
1
2
HD-SDI SLOT FILLER CONNECTORS
#
CONNECTOR
DESCRIPTION
1
SDI Out A
BNC connector for an output of digital video signals (serial digital interface, port A);
either output of YUV in single-link or first stream of RGB in dual-link mode
2
SDI Out B
BNC connector for an output of digital video signals (serial digital interface, port B);
output of the second stream of RGB in dual-link mode
NOTE:
When the RED ROCKET Breakout Box is on and connected to the RED ROCKET board, the SDI outputs
of the RED ROCKET board will become inoperative.
INSTALL THE RED ROCKET AND HD-SDI SLOT FILLER
WARNING:
The computer system you are installing the RED ROCKET in works with voltages that can be hazard-
ous to your health.
Follow the instructions below to install the RED ROCKET:
1. Ensure that the system is turned off.
2. Wait 5–10 minutes to ensure that the system components cool down.
3. Unplug the power cable and all external cables from the system.
WARNING:
Never work on the system or access its interior while any power cables are plugged in.
