20 Willow Springs Circle
• York, PA 17406 • USA • T +1 717 767 6511 • F +1 518 877 8346 • [email protected]
www.redlion.net
QUICK START GUIDE
EnterprisePro
TM
Router
USB AIRCARD R-3100 or R-1100
UNPACKING INSTRUCTIONS
1
Unpack the Red Lion Wireless unit and verify the following
components are enclosed for the EnterprisePro
TM
Router
(Figure A).
Figure A
: Package Contents R-3100 or R-1100:
Not Shown: Antenna included with model R-3100 or R-1100
* Non-US
power supplies require customer-supplied power cord to connect power
to AC power outlet
2
If any items are missing, please contact Red Lion
Wireless at +1 877 432 9908.
3
Optional item to use for Out-of-Band (OOB) Management
function of the Red Lion Wireless modem: Cisco DB9 to
RJ45 Console Cable.
PREPARATION AIRCARD MODEL R-3100 OR R-1100
1
Verify that you have one of the following supported cellular
cards: Sierra 598U, Novatel U760, AT&T Mercury C885. If
your card is not listed, see for complete list of supported
USB Aircards.
2
Using the instructions that accompanied the USB aircard,
verify that the aircard is properly activated and functioning
correctly prior to installing the card into the Red Lion
EnterprisePro
TM
Router.
3
Attach power supply connector to the “barrel” power outlet
on the back of the unit and connect power supply plug to an
AC power outlet.
5
Please allow 2-4 minutes for the unit to recognize the
cellular data card and connect to the cellular network. When
this has occurred the Signal Strength LEDs should light up
from 1 to 4 LEDs. Red Lion Wireless recommends 2 bars or
greater for proper functionality of the unit. If signal strength
is showing 1 LED or showing the top and bottom LEDs
flashing (1 and 4 positions), please refer to the User Manual
at
6
Connect to the Ethernet RJ45 port for network connectivity.
ACCESSSING THE GRAPHICAL USER INTERFACE (GUI)
1
Connect PC to EnterprisePro
TM
Router
The Ethernet Port on the EnterprisePro
TM
Router
is “auto-
sensing”, which means a straight through or cross-over
cable can be used to connect to the Red Lion router.
Connect a CAT-5 Ethernet cable between the local PC and
the unit’s Ethernet port. Verify the link LED is lit.
2
Setup PC IP Address
For assistance with configuring your PC, see the appropriate
Microsoft Windows support webpage listed at:
PC to Ethernet Interfaces
Select “Use the following IP address” and fill in the blank
fields with the information below:
Ethernet 0
Ethernet 1
IP address
192.168.0.2
192.168.1.2
Subnet mask
255.255.255.0
255.255.255.0
Default gateway
192.168.0.1
192.168.1.1
Preferred DNS
192.168.0.1
192.168.1.1
3
Access Graphical User Interface
Open a web browser & enter the following in the
address bar:
Ethernet 0:
Ethernet 1
LOGIN INSTRUCTIONS
• User Name enter:
admin
(lowercase letters)
• For Password enter:
six digit serial number of unit
(lowercase)
Upon successfully logging in you will see the following screen
.
Figure B
: GUI:
You are now connected to the Management GUI. If you should
see anything other than the GUI screen shown, please refer
to the User Manual located at:
Power Supply
(United States)
Power Supply*
(International)
Ethernet Cable
(
6’ CAT 5E 568B)
