EnduraLED Polycarbonate
Floodlights with PIR
Installation Instructions P.1
Red Arrow Trading
Elsworth House, Herries Road South, Sheffield,
S6 1QS
T:
0800 195 0006
F:
0870 043 3946
E:
www.redarrowtrading.com
This installation must be carried out by an electrician. Please read these instructions carefully
before installation. Leave a copy for the user/maintenance engineer for future reference.
For models: FLSMDPC10BOPIR, FLSMDPC20BPIR,
FLSMDPC30BPIR, FLSMDPC50BPIR
Safety Instructions
•
Ensure the power supply is switched off before
installation.
•
Do not install this floodlight where the ambient
temperature may be over 45°C
•
This floodlight must be mounted on a non-flammable
surface.
•
Ensure adequate ventilation is allowed between
floodlight and any object above, in front or to either
side. Suggested space is 0.5m above, 0.3m to either
side & 1.0m in front.
•
The floodlight can become hot during use. Allow
adequate cooling time before handling.
•
This floodlight is of Class I construction and must
be earthed.
•
Do not use this floodlight if it appears damaged in
any way. Broken or damaged glass must be replaced
immediately.
•
This floodlight must be installed in accordance with
the current edition of the IEE Wiring Regulations.
If in doubt, contact a qualified electrician.
Specification
•
Voltage: 220V-240V
•
Wattage: 10-50W
•
LED: 15-75pcs of LF SMD LED
•
Lumen Output: 800-4000lm
•
Life expectancy: 50000 hours
•
Guarantee: Two years
•
IP Rating: IP65
Installation Instructions
•
Find a suitable location to install this product.
•
Use the mounting bracket as a template to mark fixing
holes.
•
Drill fixing holes and fit suitable wall plugs, and secure
floodlight in location.
•
Feed the flexible cable to the required location for
termination.
•
When connecting the cable to the power supply, ensure the
correct polarity is observed.
- Brown to live (L)
- Blue to neutral (N)
- Green / Yellow to earth ( )
•
Adjust the floodlight to the desired angle and tighten the
bolts using a suitable allen / hex key.
•
Switch on power supply and check floodlight operation.
Maintenance Instructions
•
There are no user serviceable parts in this fitting.
•
Periodically clean the housing and lens with a clean damp
cloth and dry with a lint free cloth.
PIR Specification
•
100-240V AC Power source
•
50/60Hz Power frequency
•
Maximum 500W resistive load / maximum 200W inductive
load
•
90° Detection range
•
Maximum eight metres (adjustable) detection distance
•
Delay time adjustable between 10 seconds - 5 minutes
(5 seconds - 1 minute adjustable)
•
2~2000Lux (adjustable) Lux control
•
0.6-1.5m/s Detection motion speed
•
-10°C - +40°C Working temperature
•
1-3 metres installation height
Manual Override PIR Sensor
Instructions
Technical requirements:
This lamp has two modes:
1.
PIR Sensor mode:
