Servicing and maintenance
7
BAL_K32_K42_Z_EN_2V5_BLA_121-006454230
31 / 46
7
Servicing and maintenance
7.1
General remarks
According to current legislation, the operator of an automatic door system is responsible for its main-
tenance and safety.
Accidents or defects can be avoided if the system operator takes good care of the system.
Testing
Type of test
Measure
Visual inspection
Check door leaves, guides, bearings, limiting devices, sensors, and the securing of
crushing and shearing points for damage.
Mechanical inspection
Check fastenings for tight fit.
Safety check (exit and es-
cape routes)
Check sensors, safety devices, and monitoring devices for tight fit and damage.
Function testing
Check functioning of switches, operators, controllers, power or energy storage
devices, and sensors.
Also check the adjustment of the safety devices and the setting of all movement se-
quences including the end points.
Servicing
Type of servicing
Measure
Adjusting and cleaning
Clean and adjust bearings, sliding points, and power transmission.
For documentation and information purposes, the testing and servicing work as well as the condition
of the system are recorded in a test log book. The test log book must be kept for at least one year or
until the next testing/servicing.
IMPORTANT
The testing and/or servicing interval according to the manufacturer's specification is at least 1
to 2 times a year.
IMPORTANT
The recommended and planned spare parts and wearing parts can be requested from your
service center.
7.2
Monthly inspection work performed by the operator
The monthly tests and inspections of individual components by the operator require little time and
serve in particular to prevent accidents caused by improper handling of the system. Depending on the
equipment of the plant, we recommend that the following inspection work be carried out on a monthly
basis.
Item Nr.:
Test / Control
Procedure
Expected result
1
Function test
motion detectors
– Select the AUTOMATIC operating
mode.
– When the turnstile comes to a
standstill, enter into the detection
area of the motion detector.
– Conduct this test from the interior
and exterior.
– The turnstile must start to rotate in
time.
