Attaching to the bed unit
Loosen the fixation screw of the height adjustment and allow
the drive unit to slide up with the help of the pneumatic system.
Once the MOTOmed letto2 is positioned correctly, lock the ground
fixation (Four-Brake-Stop) by pushing the red part of the foot pedal.
If your MOTOmed letto2 is equipped with a “expandable chassis”
(accessory, item no. 160)
, you can adjust it with the control lever
according to your needs.
Adjustment of the training height
Use the handlebar to adjust the desired training height, then retighten
the fixation screw of the height adjustment . Please make sure
that the foot shells do not strike the bed while in the lowest position.
If your MOTOmed letto2 is equipped with a “hydraulic height
adjustment”
(accessory, item no.
173)
, you can adjust the training height
comfortably by pushing (raised drive unit) or pulling up (lowered drive
unit) the foot pedal.
Foot shells and leg guides
After initialization is completed, insert the feet into the foot shells
and fasten them with the fixation straps .
If your MOTOmed letto2 is equipped with a “TrainCare Comfort”
(accessory, item no.
168)
, you can assure a safe insertion of the calves and
prevent overstretching of the knees, by placing the legs into the calf
shells one after the other and fastening them with the straps.
Please make sure that the expander cords run through the plastic
coils as indicated
(fig.
“correct/wrong”)
. If the expander cords are positioned
incorrectly they can cause a safety issue and can wear out quickly.
Knee bending adjustment
Before inserting the legs loosen the wing screw of the longitudinal
adjustment and move the crank toward the user or away from him.
Retighten the wing screw securely.
If your letto2 is equipped with a “knee bending adjustment”
(accessory,
item no.
162)
. You can use the thumb wheel to adapt the strength of the
knee bending adjustment
exactly at all times, even during the training.
Make sure that the user's knee joints are slightly bend at the biggest
distance between the user and the safety foot shells.
Pivoted operating panel incl. operator remote stop:
Rotate the operating panel towards the user and provide the
user with access to the operator remote stop .
Pay attention that
the cable does not come in the training area of the foot shells.
If the MOTOmed letto2 that you are using is equipped with a
“pivot arm for operating panel”
(accessory, item no.
166)
, you can
position the operating panel in a direction that is more accessible
for the user. The user can read off the training data easier which
allows for a better control of the training session.
1
1 a
1 b
2
2 a
2 b
3
3 a
3 b
4
4 a
4 b
5
5 a
5 b
G
B 7
13
.4
/W
80
b (
en
ts
pr
. d
t. V
er
si
on “
e”
) 1
1.
14 e
bn
S
MOTOmed move differently
movement therapy: passive, motor-assisted, active resisted
MOTOmed
®
letto2
Short User Guide: Preparation
correct
wrong
