Rebel ZAB0122, User Manual

Page: 13 / 32

13
EN
HANDLEBAR HEIGHT ADJUSTMENT
1. Open the clamp.
2. With one hand holding the handlebar, keep the handlebar height
adjustment button pressed with the other hand and push the
handlebar up or down until the button locks into the desired slot.
Always make sure the button locks in one of the slots!
3. Tightly close the clamp.
FRONT LIGHT
Operation
1. Press the power button on the front light to turn on the light.
2. Keep pressing that button to switch between the modes.
3. Fourth press turns off the light.
Charging
1. Remove the front light from its slot at the front of the handlebar. To
do this, insert your finger into the notch on the top of the slot and pull
out the front light.
2. Remove the rubber plug to reveal the USB interface.
3. Connect the USB interface with the USB port of your PC or AC
charger.
4. When the battery is charging, red LED is on.
5. When the battery is fully charged, green LED is on.
6. It takes about 90 minutes to fully charge the battery.
7. When charging is finished, disconnect the front light from the USB
port and reattach the rubber plug. Install the front light back into its
slot in the scooter. To do this, first insert the bottom of the front light
into the slot, then push the front light in.
NOTE: Do not remove and reattach the front light too frequently when
charging is not needed to avoid slacks and as a result loss of the front
light during use.
LED Light
Removal notch
USB charging
interface