For the single 9-slot unit:
BASE
1.
Lay base (A) flat on a table or floor, printed side up.
Punch out the perforated pieces in the middle labeled
“Connecting Piece 1 and 2” (Fig. 1). Separate them and
save for later use.
2.
Turn base over so brown side faces up, and stand side
panels 1 and 2 up. Fold their end flaps towards the inside
of the box (Fig. 2).
Stand up end panels 3 and 4, creasing double perforations
well, and fold them over the end flaps.
The base is now assembled and ready to hold shelves.
SHELVES
3.
To assemble the shelf insert, take the two side support
pieces (B), fold them on the crease (printed sides facing
out). Stand them parallel to each other (Fig. 3).
Then fold the shelves (C) in half (printed sides facing out).
Keeping all of the label flaps facing the same way, slide each
of the ten dividers into the slots in the two support pieces.
Be certain to slide the shelves in as far as they
can go (Fig. 4).
4.
When you are finished assembling the shelf insert, position
the base open side up, and slide in the shelf unit. The smooth
edges should be facing towards the inside of the box (Fig. 5).
Classroom Mail Center Assembly Instructions
Helping Teachers Make A Difference
®
© 2008 Really Good Stuff
®
1-800-366-1920 www.reallygoodstuff.com Made in USA #157005
Number of Slots
Contents
27
18
9
A. Base Unit
3
2
1
B. Side Supports
6
4
2
C. Shelves
30
20
10
D. Back Cover
3
2
1
E. Sticker Sheet
3
2
1
All activity guides can be found online:
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
1
2
3
B
B
A
end
flap
end
flap
4
Label
flap
C
Rough edges
face out