Operating Manual
Page 93 / 116
Copyright © REA Elektronik
REA ScanCheck 3n
V 1.2.0 24/02/2020
REA
VERIFIER
5.6.1.3.4.7 Device configure <7> Company and User info
The data on this display screen is accepted for and output in the
headers of all subsequent measurement report evaluations.
To do this, control the input field with the arrow keys and mark it in
colour.
Using the <
del
.>
button, it is possible to delete existing characters to
the left.
By pressing the number buttons multiple times it is possible to enter
numbers, letters and special characters. Please note that the space
key is also assigned special characters.
The “Note” input field may contain multiple lines.
Pressing the
<OK> button
accepts the entries. Actuating the
<back> button
discards the entries
made in this menu screen.
5.6.1.3.4.8 Device configure <8> Configure long report
In these sub-menu screens it is possible to implement the settings for
the appearance of measurement reports on the printout from the
REA TD-GPT-U printer.
These settings do not change the appearance of the measurement
results in the PC software REA TransWin32 and its printout.
The detailed report
(long report)
is only printed out if the <
Print L
>
button is pressed.
On this first screen it is possible to deactivate the parameter groups
for the presentation of an individual measurement.
All parameters for the printout are activated in the factory pre-settings.
With the
Next
command it is possible to call up the next screen for
configuration of the report contents for multiple measurements.
The left-hand column shows the number of the respective multiple
measurement from 1 to 10.
In the ISO/ANSI column it is possible to activate or deactivate the
printout of the ISO/IEC 15416 parameters for each individual
measurement.
The same can be specified for the printout of the optional parameters
(Opt. P.), for the detailed evaluation (Det.ev.) and for the scan
reflectance profile (SRP).
The settings in the example shown would lead to a very long printout,
because all information for the ISO and optional parameters would be
issued for each of the 10 individual measurements.
However, if in the case of a multiple measurement a print command is
If the device has been protected with a password, a password prompt requests
entry of the correct password when the device settings are selected.
