Maintaining RDM SYNERGY II
RDM SYNERGY II performs best when all working surfaces are clean and free of foreign material.
Cleaning the Terminal
CAUTION:
Solvents or harsh cleaners may discolor the cabinetry.
To clean the outside cabinetry:
Use a damp cloth and mild soap.
To clean the inside of the unit:
To remove dust and debris from inside the
unit; open it by following the diagram to the left. Inside, use a dusting brush
designed for use on electronic equipment or a compressed air duster. To
clean the inside:
1.
Press the latch and lift the cover to access the imaging frame.
2.
Lift the imaging frame to access the document feed plate.
3.
Locate the blue tab on the right side of the unit. With your thumb
positioned on the outside of the unit, apply enough pressure to pull the
blue tab towards the outside of the unit and hold it there.
4.
While holding the blue tab, lift the document feed plate up and left to
free it from the right side.
5.
To free the left side, pull it up and to the right. Remove the plate.
19