P.O Box 578 Casino, NSW, 2470 Australia
Phone: International ++614 2902 9083
Australia (04) 2902 9083
Website:
http://rcs-rc.com
E mail:
OMEGA-3v7
E
lectronic
S
peed
C
ontroller
FULL INSTRUCTION MANUAL.
TABLE OF CONTENTS
PROVIDED IN INSTRUCTIONS.
Page # 1 Introduction.
Page # 2 Installing the
#
OMEGA-3v7
ESC.
Page # 3 Installing RX into the
#
OMEGA-3v7
.
Page # 4 Setting up the system.
Binding the RX.
Page # 5 Calibrating the system.
Page # 6 Programming the system.
Page # 7 Operating the System.
Speed & Direction control.
Using Sound Trigger functions.
Page # 8 MU’ing Consists of Locos.
Trouble shooting.
PLEASE NOTE. PDF WIRING INSTRUCTIONS ARE HERE:
http://www.rcs-rc.com/pages/instructions
Thank you for purchasing this Microprocessor based
E
lectronic
S
peed
C
ontrol
(ESC)
R/C system.
THESE INSTRUCTIONS REFER SPECIFICALLY FOR USE WITH
THE
RCS
TX-4, TX-8, TX-7 & TX-9 HANDPIECES.
THERE ARE SEPARATE INSTRUCTIONS FOR USE WITH ANY 2.4
GHz R/C WITH 4 OR MORE CHANNELS.
THOSE OTHER INSTRUCTIONS REFER SPECIFICALLY TO THE
SPEKTRUM DX5e 2.4 GHz R/C.
THEY ALSO APPLY TO THE DX4e, DX6i & PLANET T5.
N.B. YOU
CANNOT MIX BRANDS OF R/C.
THE
RCS
#
OMEGA-3v7
SYSTEM IS IN ONE PART WITH SERVO
LEADS TO PLUG INTO ANY DSM2 or DSMX RX.
OR
; USE ANY BRAND OF R/C USING THE FOUR SERVO LEADS
CONNECTED TO THE 6 WAY SCREW TERMINAL ON THE ESC
AND PLUGGED INTO THE APPROPRIATE CONNECTIONS ON
THE RX.
INSTRUCTIONS.
THESE INSTRUCTIONS REFER TO OPERATING PROGRAM
Av1
.
USED WITH ANY STICK TYPE DSM2/DSMX TRANSMITTER OR: RCS DSMX TX HANDPIECES
#
OMEGA-3v7
HAS BEEN CALIBRATED AT THE FACTORY. ONCE RX IS “BOUND” TO TX THE SYSTEM IS READY TO USE AS IS.
THERE ARE MANY FEATURES WITHIN THE SYSTEM WHICH CAN BE PROGRAMMED. YOU WILL NEED TO DOWNLOAD THE FULL
INSTRUCTION MANUAL FROM THE RCS WEBSITE. THE PUSHBUTTON ON THE ESC PCB IS ONLY USED FOR PROGRAMMING.
DO NOT PRESS THE ESC BUTTON DURING OPERATION.
DO NOT CONNECT TO MAINS POWER (110 – 240V AC).
THE
#
OMEGA-3v7
CAN BE USED WITH ANY FILTERED DC SUPPLY SUCH AS BATTERY POWER.
THEY HAVE CONSTANT BRIGHTNESS DIRECTIONAL LIGHTS & 4 SOUND TRIGGERS.
THE FOLLOWING MAXIMUM VOLTAGES MENTIONED ARE THE
NOMINAL
VOLTAGE & TAKE INTO ACCOUNT THAT FULLY
CHARGED BATTERIES CAN & DO EXCEED THE
NOMINAL
VOLTAGE.
USE MIN 14v – 20v FOR THE
#
OMEGA-3v7
. USE MIN 14v – 30v FOR THE
#
OMEGA-3v7
high voltage version.
We tested this system three times during manufacture. It was working normally when it left our factory.
If damage in transit has occurred, please return to place of purchase for attention.
THE ESC IS GUARANTEED FOR ONE YEAR.
The solid state motor driver output IC is guaranteed for life.
You will supply a locomotive or trail car, the 14 – 20 volt traction batteries (depending on ESC), a fuse,
ON-OFF switch and wires where necessary, to connect the ESC to the battery and motor(s).
Where soldering is necessary, we recommend a low wattage soldering iron and resin core solder.
TO AVOID CONFUSION WITH OTHER OPERATORS, WE SUGGEST YOU MARK THE TX TO
SHOW WHICH LOCO IT OPERATES.
CAUTION
DO NOT ATTEMPT TO ALTER THE TUNING OF THE RADIO EQUIPMENT.
DO NOT USE RADIO CONTROL EQUIPMENT IN THUNDERSTORMS.
CHILDREN UNDER 12: ADULT SUPERVISION RECOMMENDED DURING USE.
